Техническая Спецификация для Conrad Energy Button cell ZA13 Zinc air ZA13 280 mAh 1.4 V 6 pc(s) 650496

Модели
650496
Скачать
Страница из 6
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 650496
Material Safety Data Sheet
Page 4 of 6
8. Exposure controls/personal protection
Under normal conditions (discharge, avoid prolonged deep discharge) release of ingredients does not occur.
9. Physical and chemical properties
Not applicable if closed.
10. Stability and reactivity
Dangerous reactions:
When heated above 60°C the risk of rupture occurs.
11. Toxicological information
Under normal conditions (during and discharge) release of ingredients does not occur. If accidental release occurs see
information in section 2, 3, and 4. Swallowing of a battery can be harmful. Call the local Poison Control Centre for advice and
follow-up.
12. Ecological information
Our primary zinc/air button cells do contain mercury and lead, and do not contain cadmium as defined by the European
directive 2006/66/EC Article 21; they comply with the chemical composition requirements of this Directive. The mercury
content is in accordance with the ‘‘Mercury-Containing and Rechargeable Battery Management Act’’ (U.S.A.).
13. Disposal considerations
USA: Primary zinc/air button cells are classified by the federal government as non-hazardous waste and are safe for disposal
in the normal municipal waste stream.
In the European Union, manufacturing, handling and disposal of batteries is regulated on the basis of the DIRECTIVE
2006/66/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 6 September 2006 on batteries and
accumulators and waste batteries and accumulators and repealing Directive 91/157/EEC. Customers find detailed information
on disposal in their specific countries using the web site of the European Portable Batteries Association
(http://www.epbaeurope.net/legislation_national.html).
Importers and users outside EU should consider the local law and rules.
In order to avoid short circuit and heating, used zinc/air button cells should never be stored or transported in bulk. Proper
measures against short circuit are:
• Storage of batteries in original packaging
• Coverage of the terminals