Справочник Пользователя для Freescale Semiconductor Demonstration Board for Freescale MC9S12XHY256 Microcontroller DEMO9S12XHY256 DEMO9S12XHY256
Модели
DEMO9S12XHY256
Analog-to-Digital Converter (ADC12B12CV1) Block Description
MC9S12XHY-Family Reference Manual, Rev. 1.04
330
Freescale Semiconductor
10.3.2.8
ATD Compare Enable Register (ATDCMPE)
Writes to this register will abort current conversion sequence.
Read: Anytime
Write: Anytime
3–0
CC[3:0]
Conversion Counter — These 4 read-only bits are the binary value of the conversion counter. The conversion
counter points to the result register that will receive the result of the current conversion. E.g. CC3=0, CC2=1,
CC1=1, CC0=0 indicates that the result of the current conversion will be in ATD Result Register 6. If in non-FIFO
mode (FIFO=0) the conversion counter is initialized to zero at the begin and end of the conversion sequence. If
in FIFO mode (FIFO=1) the register counter is not initialized. The conversion counters wraps around when its
maximum value is reached.
counter points to the result register that will receive the result of the current conversion. E.g. CC3=0, CC2=1,
CC1=1, CC0=0 indicates that the result of the current conversion will be in ATD Result Register 6. If in non-FIFO
mode (FIFO=0) the conversion counter is initialized to zero at the begin and end of the conversion sequence. If
in FIFO mode (FIFO=1) the register counter is not initialized. The conversion counters wraps around when its
maximum value is reached.
Aborting a conversion or starting a new conversion clears the conversion counter even if FIFO=1.
Module Base + 0x0008
15
14
13
11
10
9
8
7
6
5
4
3
2
1
0
R
0
0
0
0
CMPE[11:0]
W
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 10-10. ATD Compare Enable Register (ATDCMPE)
Table 10-17. ATDCMPE Field Descriptions
Field
Description
11–0
CMPE[11:0]
Compare Enable for Conversion Number n (n= 11, 10, 9, 8, 7, 6, 5, 4, 3, 2, 1, 0) of a Sequence (n conversion
number, NOT channel number!) — These bits enable automatic compare of conversion results individually for
conversions of a sequence. The sense of each comparison is determined by the CMPHT[n] bit in the ATDCMPHT
register.
number, NOT channel number!) — These bits enable automatic compare of conversion results individually for
conversions of a sequence. The sense of each comparison is determined by the CMPHT[n] bit in the ATDCMPHT
register.
For each conversion number with CMPE[n]=1 do the following:
1) Write compare value to ATDDRn result register
2) Write compare operator with CMPHT[n] in ATDCPMHT register
2) Write compare operator with CMPHT[n] in ATDCPMHT register
CCF[n] in ATDSTAT2 register will flag individual success of any comparison.
0 No automatic compare
1 Automatic compare of results for conversion n of a sequence is enabled.
0 No automatic compare
1 Automatic compare of results for conversion n of a sequence is enabled.
Table 10-16. ATDSTAT0 Field Descriptions (continued)
Field
Description