Техническая Спецификация для Freescale Semiconductor Tower System Eval Kit for MC9S12GN32 TWR-S12GN32-KIT TWR-S12GN32-KIT

Модели

TWR-S12GN32-KIT

192 KByte Flash Module (S12FTMRG192K2V1)

MC9S12G Family Reference Manual, Rev.1.23

Freescale Semiconductor

1125

30.4.6.7

Erase All Blocks Command

The Erase All Blocks operation will erase the entire P-Flash and EEPROM memory space.

Upon clearing CCIF to launch the Erase All Blocks command, the Memory Controller will erase the entire
Flash memory space and verify that it is erased. If the Memory Controller verifies that the entire Flash
memory space was properly erased, security will be released. During the execution of this command
(CCIF=0) the user must not write to any Flash module register. The CCIF flag will set after the Erase All
Blocks operation has completed.

30.4.6.8

Erase Flash Block Command

The Erase Flash Block operation will erase all addresses in a P-Flash or EEPROM block.

Table 30-43. Program Once Command Error Handling

Register

Error Bit

Error Condition

FSTAT

ACCERR

Set if CCOBIX[2:0] != 101 at command launch

Set if command not available in current mode (see

Table 30-27

)

Set if an invalid phrase index is supplied

Set if the requested phrase has already been programmed

If a Program Once phrase is initially programmed to 0xFFFF_FFFF_FFFF_FFFF, the Program Once command will
be allowed to execute again on that same phrase.

FPVIOL

None

MGSTAT1

Set if any errors have been encountered during the verify operation

MGSTAT0

Set if any non-correctable errors have been encountered during the verify
operation

Table 30-44. Erase All Blocks Command FCCOB Requirements

CCOBIX[2:0]

FCCOB Parameters

000

0x08

Not required

Table 30-45. Erase All Blocks Command Error Handling