Справочник Пользователя для Ideal Networks SignalTEK IICable length meter, R156000
Модели
R156000
156810 Iss 2
SignalTEK II
Page 4
User Guide
Introduction
SignalTEK II comprises two hand-held units and a set of standard accessories all held in a semi-rigid
case.
case.
Two models are available, SignalTEK II and SignalTEK II FO. Both models are capable of performing the
same range of tests. SignalTEK II has RJ45 connectivity; SignalTEK II FO has both RJ45 and Fiber
connectivity.
same range of tests. SignalTEK II has RJ45 connectivity; SignalTEK II FO has both RJ45 and Fiber
connectivity.
Fig 1
SignalTEK II components
The Near-End unit is the terminal from where all tests are run and stored. The Remote Unit is a loopback
terminal that enables performance testing. The Near-End Unit and Remote Unit are paired. When they
are both connected to the same network, the Near-End Unit will find the Remote Unit that it is uniquely
paired with, and not any other SignalTEK II Remote Unit that may be connected to the same network.
The Near-End unit may be used as a stand-alone device for wiremap testing copper network cables.
When both units are directly connected by a cable, wiremap and cable performance tests can be run.
When the Near-End Unit is connected to a network, it can be used to carry out a range of IP tests. When
both the Near-End and Remote Unit are connected to an active network, both IP tests and network
performance tests are possible.
When both units are directly connected by a cable, wiremap and cable performance tests can be run.
When the Near-End Unit is connected to a network, it can be used to carry out a range of IP tests. When
both the Near-End and Remote Unit are connected to an active network, both IP tests and network
performance tests are possible.
This manual describes the operation and functions of the SignalTEK II FO. If you are using SignalTEK II
please disregard all references to fiber optics.
please disregard all references to fiber optics.