Техническая Спецификация для Ea Elektro Automatik EA Elektro-Automatik EA-ELR 91500-30 3U Electronic Load 0 - 30 A 0 - 1500 Vdc 0 - 10500 W 33200414
Модели
33200414
Page 6
ELR 9000 Series
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
1.4
Disposal of equipment
A piece of equipment which is intended for disposal must, according to European laws and regulations (ElektroG,
WEEE) be returned to EA Elektro-Automatik for scrapping, unless the person operating the piece of equipment or
another, delegated person is conducting the disposal. Our equipment falls under these regulations and is accord-
ingly marked with the following symbol:
1.5
Product key
Decoding of the product description on the label, using an example:
ELR 9 1500 - 30 xx zzz
Field for identification of installed options and/or special models
S01...S0x = Special models with or without options
S01...S0x = Special models with or without options
Construction (not always given)
2U / 3U / 4U = 19” enclosure with 2U, 3U or 4U
2U / 3U / 4U = 19” enclosure with 2U, 3U or 4U
Maximum current of the device in Ampere
Maximum voltage of the device in Volt
Series :
Maximum voltage of the device in Volt
Series :
8 = Series 8000 or 800, 9 = Series 9000 etc.
Type identification:
PS = Power Supply, usually programmable
PSI = Power Supply Intelligent, always programmable
EL = Electronic Load, always programmable
ELR = Electronic Load with Recovery
BC = Battery Charger, not programmable
BCI = Battery Charger Intelligent, programmable
PS = Power Supply, usually programmable
PSI = Power Supply Intelligent, always programmable
EL = Electronic Load, always programmable
ELR = Electronic Load with Recovery
BC = Battery Charger, not programmable
BCI = Battery Charger Intelligent, programmable
Special models are always derived from standard models and can vary in input voltage and
current from those given.
1.6
Intended usage
The equipment is intended to be used, if a power supply or battery charger, only as a variable voltage and current
source, or, if an electronic load, only as a variable current sink.
Typical application for a power supply is DC supply to any relevant user, for a battery charger the charging of vari-
Typical application for a power supply is DC supply to any relevant user, for a battery charger the charging of vari-
ous battery types and for electronic loads the replacement of Ohm resistance by an adjustable DC current sink in
order to load relevant voltage and current sources of any type.
•
Claims of any sort due to damage caused by non-intended usage will not be accepted.
•
All damage caused by non-intended usage is solely the responsibility of the operator.