Техническая Спецификация для Atmel Xplained Pro Evaluation Kit ATSAMD20-XPRO ATSAMD20-XPRO
Модели
ATSAMD20-XPRO
646
Atmel | SMART SAM D20 [DATASHEET]
Atmel-42129K–SAM-D20_datasheet–06/2014
36.9
Rev. C – 07/2013
DSU
Updated the
z
Removed HRAM from the block diagram
Clock System
Updated
z
The description of the Basic Read Request has been updated
z
Updated the
SYSCTRL
z
Updated the writing of the interrupt sources in
z
Added the reference to
NVMCTRL
Updated the
z
Removed the blue mark from the figure
PORT
z
: IOBUS address 0x60000000 added
z
Removed RWM from the description
EVSYS
Channel register (
z
Bits 25:24: CHANNEL:PATH description updated.
Schematic Checklist
Updated the
z
z
Replaced all TDB by their respective values
z
Wrote correctly the Ohm symbol in
Electrical
Characteristics
Characteristics
z
z
z
Added footnote in the
. f
ADC
= 6 * CLK
ADC
Table Of Contents
z
Applied correctly the template for the TOC
Description
Updated the front page:
z
Removed the “Embedded Flash” from the title and from the description on the page 1
z
Replaced “speeds” by “frequencies” on the page 1
z
Added a sub-bullet on PTC in feature list (256-Channel capacitive touch and proximity
sensing) on the page 2
sensing) on the page 2
z
Replaced IO lines by IO pins on the page 2
Configuration
Summary
Summary
Updated the table
z
The RTC
z
I/O lines changed to I/O pins
z
Changed 32.768kHz high-accuracy oscillator to 32.768kHz oscillator
z
Changed 32.768kHz ultra-low power internal oscillator to 32kHz ULP oscillator
z
Changed 8MHz internal oscillator to 8MHz high-accuracy internal oscillator
z
Updated SW Debug Interface
z
Updated the WDT
Ordering
information
information
z
Replaced “base line” by “general purpose”
z
Centered the tables except the ordering code table.
About the
Document
Document
z
Renamed the chapter to Appendix A and Appendix B
z
Moved the two Appendixes at the end of the datasheet
z
Changed the tag of the tables to the tag of appendix tables