Техническая Спецификация для Atmel ATmega328P Xplained Mini MEGA328P-XMINI MEGA328P-XMINI
Модели
MEGA328P-XMINI
213
ATmega48A/PA/88A/PA/168A/PA/328/P [DATASHEET]
Atmel-8271H-AVR- ATmega-Datasheet_08/2014
It is the user software’s responsibility to ensure that these illegal arbitration conditions never occur. This implies
that in multi-master systems, all data transfers must use the same composition of SLA+R/W and data packets.
In other words: All transmissions must contain the same number of data packets, otherwise the result of the
arbitration is undefined.
that in multi-master systems, all data transfers must use the same composition of SLA+R/W and data packets.
In other words: All transmissions must contain the same number of data packets, otherwise the result of the
arbitration is undefined.
22.5
Overview of the TWI Module
The TWI module is comprised of several submodules, as shown in
. All registers drawn in a thick line
are accessible through the AVR data bus.
Figure 22-9.
Overview of the TWI Module
22.5.1 SCL and SDA Pins
These pins interface the AVR TWI with the rest of the MCU system. The output drivers contain a slew-rate
limiter in order to conform to the TWI specification. The input stages contain a spike suppression unit removing
spikes shorter than 50 ns. Note that the internal pull-ups in the AVR pads can be enabled by setting the PORT
bits corresponding to the SCL and SDA pins, as explained in the I/O Port section. The internal pull-ups can in
some systems eliminate the need for external ones.
limiter in order to conform to the TWI specification. The input stages contain a spike suppression unit removing
spikes shorter than 50 ns. Note that the internal pull-ups in the AVR pads can be enabled by setting the PORT
bits corresponding to the SCL and SDA pins, as explained in the I/O Port section. The internal pull-ups can in
some systems eliminate the need for external ones.
22.5.2 Bit Rate Generator Unit
This unit controls the period of SCL when operating in a Master mode. The SCL period is controlled by settings
in the TWI Bit Rate Register (TWBR) and the Prescaler bits in the TWI Status Register (TWSR). Slave operation
does not depend on Bit Rate or Prescaler settings, but the CPU clock frequency in the Slave must be at least 16
in the TWI Bit Rate Register (TWBR) and the Prescaler bits in the TWI Status Register (TWSR). Slave operation
does not depend on Bit Rate or Prescaler settings, but the CPU clock frequency in the Slave must be at least 16
TWI Unit
Address Register
(TWAR)
Address Match Unit
Address Comparator
Control Unit
Control Register
(TWCR)
Status Register
(TWSR)
State Machine and
Status control
SCL
Slew-rate
Control
Spike
Filter
SDA
Slew-rate
Control
Spike
Filter
Bit Rate Generator
Bit Rate Register
(TWBR)
Prescaler
Bus Interface Unit
START / STOP
Control
Arbitration detection
Ack
Spike Suppression
Address/Data Shift
Register (TWDR)