Справочник Пользователя для Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-NANO IMX233-OLINUXINO-NANO
Модели
IMX233-OLINUXINO-NANO
OLIMEX© 2013
iMX233-OLinuXino-NANO user's manual
2.5 Using BitBurner
IMPORTANT! MODIFYING THE FUSES IS IRREVERSIBLE PROCESS! BURNING THE
WRONG FUSES MIGHT DAMAGE OLINUXINO IRREVERSIBLY! BURNING WRONG
FUSES MIGHT CAUSE BOOT PROBLEMS!
WRONG FUSES MIGHT DAMAGE OLINUXINO IRREVERSIBLY! BURNING WRONG
FUSES MIGHT CAUSE BOOT PROBLEMS!
BURN FUSES AT OWN RISK!
The bit burning is done via the USB of the computer connected to the USB HOST connector
OLINUXINO board and the BitBurner software. To be able to burn the fuses you will need to make
a custom cable that connects a USB with the USB of your connector.
OLINUXINO board and the BitBurner software. To be able to burn the fuses you will need to make
a custom cable that connects a USB with the USB of your connector.
2.6 Building the Linux image
Notes on building the Linux image might be found at the following blog post:
2.7 How to setup the I2C, SPI, UART
There are number of examples with our extension module board to achieve those connections on the
UEXT. The examples might be used as an example for I2C, SPI or UART communication. You can
find them at our GitHub page:
UEXT. The examples might be used as an example for I2C, SPI or UART communication. You can
find them at our GitHub page:
Page 10 of 35