Справочник Пользователя для Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-NANO IMX233-OLINUXINO-NANO
Модели
IMX233-OLINUXINO-NANO
OLIMEX© 2013
iMX233-OLinuXino-NANO user's manual
Notice that the pad numeration is written at the bottom of OLinuXino-NANO under the microSD
card connector. Please check the manual part for microSD card for a schematic of the pins.
card connector. Please check the manual part for microSD card for a schematic of the pins.
6.2 SD/MMC slot
The microSD card slot is a standard 8pin connector.
We have tested a number of microSD cards on the OLinuXino boards and all of them worked fine
regardless manufacturer or capacity. However, keep in mind that some of the lower quality
microSD cards might draw too much current from the slot which might cause power-state problems.
If you suspect the microSD card is causing problems please try using another one of better quality
for better results.
regardless manufacturer or capacity. However, keep in mind that some of the lower quality
microSD cards might draw too much current from the slot which might cause power-state problems.
If you suspect the microSD card is causing problems please try using another one of better quality
for better results.
microSD card connector
Pin #
Signal name
Processor pin #
1
SSP1_DATA2
86
2
SSP1_DATA3
87
3
SSP1_CMD
83
4
SD_VCC
-
5
SSP1_SCK
90
6
GND
-
7
SSP1_DATA0
84
Page 19 of 35