Справочник Пользователя для Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-NANO IMX233-OLINUXINO-NANO
Модели
IMX233-OLINUXINO-NANO
OLIMEX© 2013
iMX233-OLinuXino-NANO user's manual
USB HOST
Pin #
Signal name
1
+5V_HOST_PWR
2
USB_DM
3
USB_DP
4
GND
6.6 External power pins
The NANO board lacks power jack. If you wish to use regulated 5VDC you should provide it at
pins 1 and 2 at the CON2 row of pins. Note that pin 1 is the VDC pins and pin 2 is the GND pin.
pins 1 and 2 at the CON2 row of pins. Note that pin 1 is the VDC pins and pin 2 is the GND pin.
You would damage the board if you short-circuit the power supply to these pins!
More info about the power supply can be found in chapter 5 of this manual.
6.7 Battery connector
The voltage of a 3.7V LIPO battery would be enough to power the board. It uses the standard.
Pin #
Signal name
1
VBAT
2
GND
The pins are also written on the bottom of the board, under the connector.
Page 25 of 35