Справочник Пользователя для Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-NANO IMX233-OLINUXINO-NANO
Модели
IMX233-OLINUXINO-NANO
OLIMEX© 2013
iMX233-OLinuXino-NANO user's manual
6.10 Additional hardware components
The components below are mounted on OLinuXino but are not discussed above. They are listed
here for completeness:
here for completeness:
Reset button - used to reset the board
Power button – when Linux is running pressing PWR_BUT will put the board in low power mode;
when powered by battery PWR_BUT is used to initially power up the board – and pressing the
board again after it is powered will put it low power mode
when powered by battery PWR_BUT is used to initially power up the board – and pressing the
board again after it is powered will put it low power mode
Recovery button - when powered by battery the recovery button is used to bring the processor to
normal power mode
normal power mode
512 (32M x 16) MBit DDR SDRAM - the exact memory used at the moment of writing is Xylinx
H5DU5xxxyyy
H5DU5xxxyyy
Green LED1
6.11 Accessories
Here you will find additional information for Olimex products you can use with OLinuXino-NANO
purchase
purchase
6.11.1 USB-SERIAL-CABLE-F
The cable for the U_DEBUG interface that can be purchased for additional cost has three cables. It
is important to specify in your purchase order whether you want the USB-SERIAL-CABLE-F
variant with male of female connectors.
is important to specify in your purchase order whether you want the USB-SERIAL-CABLE-F
variant with male of female connectors.
You will need a drivers that can be downloaded from the page of USB-SERIAL-CABLE:
Page 28 of 35