Справочник Пользователя для Olimex Open Source Hardware Electrocardiography electromyography shield for DUINOMITE, PINGUINO, MAPLE, ARDUINO like developmen SHIELD-EKG-EMG
Модели
SHIELD-EKG-EMG
OLIMEX© 2012
SHIELD-EKG-EMG
SECTION 2 SETTING UP THE SHIELD-EKG-EMG
This section helps you set up the SHIELD-EKG-EMG
development board for the first time.
Please consider first the electrostatic warning to avoid damaging the board, then discover the
hardware and software required to operate the board.
hardware and software required to operate the board.
The procedure to power up the board is given, and a description of the default board behavior
is detailed.
is detailed.
2.1 Electrostatic Warning
The SHIELD-EKG-EMG
development board is shipped in a protective anti-static package.
The board must not be exposed to high electrostatic potentials. A grounding strap or similar
protective device should be worn when handling the board. Avoid touching the component
pins or any other metallic element.
protective device should be worn when handling the board. Avoid touching the component
pins or any other metallic element.
2.2 Requirements
In order to set up the SHIELD-EKG-EMG prototype board, the following items are required:
- SHIELD-EKG-EMG itself
- ARDUINO compatible board* (e.g. OLIMEXINO-328, OLIMEXINO-STM32, PIC32-
PINGUINO)
- Electrode cable**
- ARDUINO compatible board* (e.g. OLIMEXINO-328, OLIMEXINO-STM32, PIC32-
PINGUINO)
- Electrode cable**
*The pinout for the board strictly follows the DUINO extension specification. Best choice for
a board would be OLIMEXINO-328 or any DUINO board which utilizes the ATmega328
since we have working and tested examples for those MCUs, configuring them for
ATmega128 would require tweaking of the code.
a board would be OLIMEXINO-328 or any DUINO board which utilizes the ATmega328
since we have working and tested examples for those MCUs, configuring them for
ATmega128 would require tweaking of the code.
**The cable features three electrodes – two data electrodes (1 channel) and DLR electrode
(feedback). If you use more than one SHIELD-EKG-EMG you can use cables without DLR
for every shield after the first.
(feedback). If you use more than one SHIELD-EKG-EMG you can use cables without DLR
for every shield after the first.
IMPORTANT NOTE: The electrode cables for SHIELD-EKG-EMG and MOD-EEG-SMT
differ from each other.
differ from each other.
In case you want to build a working SHIELD-EKG-EMG system without owning a DUNIO
board the best choice would be our board OLIMEXINO-328. This is the web page for the
board:
board the best choice would be our board OLIMEXINO-328. This is the web page for the
board:
Page 7 of 20