Техническая Спецификация для Conrad Energy remote control ARF 2185 mm ROC006

 

Before connecting the flight battery to the model, the transmitter must be taken into operation. Observe 

that the control lever/switch for the motor function is in the bottom position (motor off).

Install the flight battery (1) centred in the fuselage tip and fasten it with hook-and-loop tape (2). Connect it to the 

model electronics via the plug connector (3) protected against polarity reversal.
The electronics now check the battery voltage and the position „motor off“. After approx. 2 hours, a sound sequence 

is issued (via a short activation of the motor). this signals that the model is ready for operation. 
Rudder, elevator, aileron, the wing flaps and the motor now react to the movements of the control levers/switches at 

the transmitter. Regarding the flight controller, also observe the notes in chapter 14.

  Figure 7, item 4, shows the flight controller, which should ideally by installed to the side of the fuselage 

with double-sided adhesive tape. 

 

The matching plugs/sockets must be present in the correct polarity at the flight battery and the flight 

controller. 

 

A matching plug for the rechargeable battery is not part of the scope of delivery and must be purchased 

separately. When soldering on, observe the correct polarity (red cable = plus/+, black cable = minus/-).