Техническая Спецификация для Conrad Energy remote control ARF 2185 mm ROC006

Fly large, flat circles with the motor on. Do not pull on the elevator too hard to reduce the flying altitude slowly. 

Select the last curve before approaching for a landing so that you will touch down against the wind and so that, 

in case of an emergency, you would have sufficient room for landing and so that you would not have to make any 

considerable corrections to the course during the approach for a landing. 
Always ensure sufficient flying speed and do not slow down the model by reducing the flight speed too much (e.g. 

by pulling too hard at the elevator). The model is only brought down with careful application of the elevator briefly 

before touchdown. If you have programmed a „Butterfly“ computer radio remote control, you can land precisely with 

careful control of this function. 
If you had to adjust the trim at the transmitter, correct the trim at the plane after touchdown (linkage wires for aileron, 

rudder and elevator) so that the trim at the transmitter is in the middle position again and the model still flies straight; 

see next section.

The rods for the rudders should be set at the flight model so that the trims at the transmitter are in the middle positi-

on. Thus, the entire trimming path for adjustment in flight is retained.
After the flight, remember the current trim position of every single rudder flap. Now set the trims at the transmitter 

to the middle position with the model ready for operation. Then mechanically set the rudder linkages to match the 

previous trim position.