Техническая Спецификация для Conrad Energy RtF 900 mm FMS064
Модели
FMS064
73
18. Renewing the Transmitter/Receiver Binding
To ensure that 2.4 GHz remote controls can transfer their signal without interference, the transmitter and receiver
must have the same digital code. Alignment of the digital encoding (binding between transmitter and receiver) is
performed with the binding function.
Transmitter and receiver are usually already aligned with each other or bound in the factory and can be used at
Transmitter and receiver are usually already aligned with each other or bound in the factory and can be used at
once.
Binding only needs to be performed again after a receiver or transmitter change or to remove a malfunction, and is
Binding only needs to be performed again after a receiver or transmitter change or to remove a malfunction, and is
displayed at the recipient by a green LED flashing quickly.
Since different manufacturers use different encoding methods, transmitter and receiver cannot be combined and
Since different manufacturers use different encoding methods, transmitter and receiver cannot be combined and
operated with products of other manufacturers.
Re-establishing the binding:
Connect the flight battery with the transmitter switched on. The green LED in the receiver will flash slowly for no
Connect the flight battery with the transmitter switched on. The green LED in the receiver will flash slowly for no
more than a few seconds to indicated binding. When the transmitter is recognised, the LED will remain lit green. If
the receiver does not find any transmitter with the same coding, the LED in the receiver will flash quickly.
1. Push the biding button from above now with the transmitter switched off (see figure 1, item 4) and hold it there.
2. Switch on the transmitter with the binding button pushed and then release the binding button.
The transmitter switches to binding mode. The LED in the transmitter flashes alternatingly red / green. After a
1. Push the biding button from above now with the transmitter switched off (see figure 1, item 4) and hold it there.
2. Switch on the transmitter with the binding button pushed and then release the binding button.
The transmitter switches to binding mode. The LED in the transmitter flashes alternatingly red / green. After a
few seconds, the binding phase is completed. The transmitter and the model pass to a regular operating condi-
tion.
You can recognise successful binding by the transmitter and receiver LEDs remaining lit green.
3. Now check correct function of the remote control system.
3. Now check correct function of the remote control system.