Справочник Пользователя для E-flite UMX Carbon Cub SS BNF EFLU1180
Модели
EFLU1180
5
EN
Your aircraft comes with a 2-Cell 7.4V 180mAh 20C
Li-Po battery and a Celectra
Li-Po battery and a Celectra
™
2S 7.4V DC Li-Po
Charger that requires a 12V (11V-14V) DC power
source.
source.
Refer to the battery warnings. It is recommended
to charge the battery pack while you are inspecting
the aircraft. The fl ight battery will be required to
confi rm proper aircraft operation in future steps.
to charge the battery pack while you are inspecting
the aircraft. The fl ight battery will be required to
confi rm proper aircraft operation in future steps.
Please visit www.horizonhobby.com for optional
battery adapters.
battery adapters.
Charging the Battery
The Battery Charging Process
1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not
damaged e.g., swollen, bent, broken or punctured.
2. The connector of the battery is specifi cally designed to allow it to fi t into the charge port one way to prevent
reverse polarity connection. However, check for proper alignment and polarity before proceeding to the next step.
3. Gently press the battery connector into the charge port located on the front of the charger.
4. When you make the connection successfully, the green LED blinking on the charger slows, indicating
proper connection.
5. Press the button on the charger. The red LED will illuminate, indicating charging has begun.
6.
Charging a fully discharged (not over-discharged) 180mAh battery takes approximately 50–60
minutes at the included charger’s 300mA charge rate. The included battery can be charged at a rate
of up to 3C (540mA).
minutes at the included charger’s 300mA charge rate. The included battery can be charged at a rate
of up to 3C (540mA).
7. When the battery is fully charged, the green LED will turn solid.
8. Always unplug the battery from the charger immediately upon completion of charging.
CAUTION: Overcharging a battery can cause a fi re.
2S 7.4V 180mAh 20C
Lithium Polymer Batter
y
CAUTION: Only use a charger specifi cally designed to charge a Li-Po battery. Failure to do so could
result in fi re causing injury or property damage.
result in fi re causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.
LED Functions under normal operation
1. Green LED blinking with power connected but without battery ................................... Standby
2. Green LED blinking .................................................................................................... Battery is connected
3. Blinking Red LED at varying speeds ........................................................................... Charging
4. Red and Green LED blinking simultaneously ............................................................... Balancing
5. Solid Green LED ....................................................................................................... Full Charge
6. Red and Green LED fl ashing rapidly ........................................................................... Error
2. Green LED blinking .................................................................................................... Battery is connected
3. Blinking Red LED at varying speeds ........................................................................... Charging
4. Red and Green LED blinking simultaneously ............................................................... Balancing
5. Solid Green LED ....................................................................................................... Full Charge
6. Red and Green LED fl ashing rapidly ........................................................................... Error