Справочник Пользователя для Reely Brushed 1:10 RC model car Electric Truggy QCO10E4W096EV61R01
Модели
QCO10E4W096EV61R01
30
b) Commissioning
The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
included in it as well as any other information!
• Only use suitable drive batteries for the vehicle. Never operate the speed controller with a mains adapter, not even
for test purposes.
This vehicle is exclusively suitable for use with NiMH rechargeable batteries with 6 cells (rated voltage
7.2 V).
7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle’s drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Apart from this, the vehicle’s drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
The speed controller is generally also suitable for use with LiPo batteries with 2 cells (rated voltage 7.4 V).
However, it has no undervoltage recognition/switch-off. When using LiPo batteries, there therefore is a
damage of deep discharge, which will damage the LiPo batteries! The slightly higher rated voltage of 2-cell
LiPo batteries also poses a danger of overheating or overload of the speed controller and engine, loss of
warranty/guarantee!
However, it has no undervoltage recognition/switch-off. When using LiPo batteries, there therefore is a
damage of deep discharge, which will damage the LiPo batteries! The slightly higher rated voltage of 2-cell
LiPo batteries also poses a danger of overheating or overload of the speed controller and engine, loss of
warranty/guarantee!
Therefore, operate the vehicle only with a 6-cell NiMH battery pack with a rated voltage of 7.2 V as described
initially.
initially.
• Always switch on the transmitter first when taking the vehicle into operation. Only then must the vehicle’s drive
battery be connected with the speed controller and the speed controller switched on. Otherwise, the vehicle may
show unpredictable responses!
show unpredictable responses!
Place the vehicle on an appropriate support before connecting the drive battery so that the wheels can
turn freely.
turn freely.
Check the position of the on/off switch of the speed controller and place it in the “OFF” position (switched
off).
off).
Switch on the transmitter if you haven’t done it already. Check its function (e.g. operation display of the
transmitter). Exchange the batteries/rechargeable batteries when they become low.
transmitter). Exchange the batteries/rechargeable batteries when they become low.
Put the trimming for the throttle/brake function at the transmitter into the centre position.
Now connect a fully charged drive battery to the speed controller. As described above already, only a
NiMH drive battery with 6 cells (rated voltage 7.2 V) must be used.
NiMH drive battery with 6 cells (rated voltage 7.2 V) must be used.
Hold the vehicle, but do not reach into the drive unit. There is a risk of serious injury! Never hold the vehicle
by its wheels!
by its wheels!
Only then switch on the speed controller (switch position e.g. labelled “ON”).
• Check that the vehicle reacts to remote control commands as expected (steering and drive) before taking it from the
support and placing it on the ground with its wheels.
Set the trimming for throttle/brake lever at the transmitter so that the engine no longer turns when the
throttle/brake lever is released (neutral position).
throttle/brake lever is released (neutral position).
Set the transmitter trim for steering so that the front wheels are about straight. The exact setting for straight
driving can be performed during a drive.
driving can be performed during a drive.