Справочник Пользователя для Reely Brushless 1:18 RC model car Electric Bugg FS73607
Модели
FS73607
38
9. Commissioning
a) Open/Remove Car Body
Pull out the two safety clips (1) at the rear end of the vehic-
le and carefully fold the car body forward.
There is a power cable between the LEDs on the top of the
There is a power cable between the LEDs on the top of the
vehicle and the receiver. Ensure that it is not damaged.
If the cable (2) can be unplugged, pull the associated plug
(3) from the receiver.
Remember the proper alignment (all black cables of the
Remember the proper alignment (all black cables of the
steering servo, speed controller and LED lamps point to
the same side).
Now the car body can be tipped all the way forward.
Now the car body can be tipped all the way forward.
To completely disconnect the car body from the chassis,
first turn out the two little screws (4) at the joint between
the car body and the chassis with a suitable cross-head
screwdriver.
Then the car body can be removed from the chassis.
Then the car body can be removed from the chassis.
During assembly, observe that the plug (3) of the LED lamps is correctly connected to the receiver (all black
cables of the steering servo, speed controller and LED lamps point to one side).
1
1
2
3
4
4