Справочник Пользователя для Reely Brushless 1:18 RC model car Electric Bugg FS73607

Switch on the speed controller by moving the slider (see figure in chapter 9. f) towards the setup button (switch

position „ON“). Then wait for a few seconds (leave the throttle/brake lever on the transmitter in the neutral position; 

do not move it). 

  If the vehicle drive starts although the throttle/brake on the transmitter is in the neutral position, then adjust 

the trim on the transmitter until the motor stops. 

If the trimming path is insufficient, the neutral position must be programmed, see chapter 10. a).

Now check the drive and steering functions of the vehicle.
For programming the speed controller, please observe chapter 10. b).

 

If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether 

undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the 

LiPo battery will suffer deep discharge and be destroyed.

 

If a NiMH driving battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo 

batteries, see chapter 10. b).

The LED at the speed controller goes out in the neutral position or is lit in red when driving forward and backwards. 

The LED lights up green when driving forwards and at full throttle.

Fold the car body closed and guide the aerial tube through the corresponding opening from the bottom of the car body. 

Fasten the car body at the chassis with the two safety clips (see chapter 9. a).

Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.
Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too fast at 

the beginning until you get used to the car‘s reactions. Do not make any quick and jerky movements with the operating 

elements of the remote control.
Never point the transmitter aerial directly onto the vehicle. It will strongly decrease the range. The maximum range will 

be achieved when the aerial of the transmitter and vehicle are both vertical and in parallel to each other.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in the neutral position briefly

(neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward to reverse directly, 

the brake function of the drive is activated (vehicle will NOT reverse). 
Wait for at least 5 - 10 minutes until motor and speed controller have cooled down sufficiently before the next run. Only

then start a new drive with a full drive battery.