Справочник Пользователя для Reely Brushed 1:10 RC model car Electric Buggy QCO10E4W000EV61R02

The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 8. c) and d).

This vehicle is exclusively suitable for use with NiMH or NiCd rechargeable batteries with 6 cells (rated
voltage 7.2 V).

When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle’s drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!

The speed controller installed in the vehicle can generally also be operated with a 2-cell LiPo battery
(rated voltage 7.4 V), but it has no undervoltage recognition function! This may lead to deep discharge of
the LiPo battery and damage it.

Remove the two hook-and-loop tapes of the battery holder. Place the drive battery into the battery holder and fasten it
with the two hook-and-loop tapes. Tighten the hook-and-loop tapes to secure the drive battery.

First switch on the transmitter, as described in
chapters 8. c) and d).

Switch off the speed controller. Put the On/Off
switch (see arrow in the figure to the right) into
the „OFF“ position for this.

To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the
trimming for the drive is maladjusted), place the model vehicle on a suitable support (or starting box), so
that the wheels can turn freely in case of an error.

Do not reach into the drive. Do not hold the wheels.

Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-).

§