Справочник Пользователя для Reely Brushed 1:10 RC model car Electric Buggy QCO10E4W000EV61R02
Модели
QCO10E4W000EV61R02
37
For example, the voltage of the drive battery decreases for a short time under full throttle, so that the
receiver will no longer receive the required operating voltage. The vehicle will speed up, but the steering
servo does not react properly. Stop operating the vehicle at once and use a new, fully charged drive
battery.
receiver will no longer receive the required operating voltage. The vehicle will speed up, but the steering
servo does not react properly. Stop operating the vehicle at once and use a new, fully charged drive
battery.
Before inserting a new, fully charged drive battery into the vehicle, wait at least 5 - 10 minutes until motor
and speed controller have cooled down sufficiently.
and speed controller have cooled down sufficiently.
i) Stopping the Vehicle
To stop driving, proceed as follows:
• Let go of the throttle/brake lever on the transmitter so that it goes into neutral position, and let the vehicle run out.
• Once the vehicle is stationary, switch off the speed controller (for switch position see figure in chapter 8. f).
Never touch the wheels or the drive mechanism, and make sure you do not move the throttle/brake lever
at the transmitter!
at the transmitter!
• Disconnect the drive battery from the speed controller. Disconnect the plug connection completely.
• It is only now that the transmitter may be turned off.
Attention!
The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!
immediately after operation. Danger of burns!