Справочник Пользователя для Carson Brushless 1:8 RC model car Electric Bugg 500409091

At any time when the throttle is located in neutral zone (except in the 
throttle calibration process or ESC program mode), you can hold the 
“SET” key for over 3 seconds. The red LED and green LED will flash at 
the same time, which means each programmable item has be reset to 
its default value. 

•  Alert tone input voltage abnormal: 

The ESC begins to check the input voltage when power on. If it is 
out of the normal range, such an alert tone will be emitted: 
“beep-beep-, beep-beep-, beep-beep-” (There is 1 second time 
interval between every “beep-beep-” tones).

•  Alert tone throttle signal abnormal: 

When the ESC can’t detect the normal throttle signal, such an alert 
tone will be emitted: 
“beep-, beep-, beep-” (There is 2 seconds time interval between 
every “beep-” tones).

1.  Low voltage cut-off protection: If the voltage of a lithium battery 

pack is lower than the threshold for 2 seconds, the ESC will cut of 
the output power. Please note, that the ESC cannot be restarted if 
the voltage of one lithium cell is lower than 3.5 V. 

2.  Over-heat protection: When the temperature of the ESC is over a 

factory preset threshold for 5 seconds, the ESC will cut off the 
output power. When the over-heat protection happens, the green 
LED will flash in such a style: “✼, ✼, ✼” (single flash).

3.  Signal loss protection: The ESC will cut off the output power if the 

throttle signal is lost for 0.2 second.

•   In normal use, if the throttle stick is in the neutral range, neither the 

red LED nor the green LED lights.

•  The red LED lights when the car is running forward or backward and 

it will flash quickly when the car is braking.

•   The green LED lights when the throttle stick is moved to the top 

point (end point) of the forward zone or backward zone.