Техническая Спецификация для Kcl 5-minute epoxy-resin 200 g EPO5.S200
Модели
EPO5.S200
5 Min. Epoxy (resin)
Safety Data Sheet
Product code: 155105-GHS-2014
Print date: 08.08.2014
Page 4 of 10
R&G Faserverbundwerkstoffe GmbH
according to Regulation (EC) No 1907/2006
7.2. Conditions for safe storage, including any incompatibilities
Keep container tightly closed.
Requirements for storage rooms and vessels
No special measures are necessary.
Advice on storage compatibility
7.3. Specific end use(s)
Epoxy resin products, solvent-free, sensitising
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
8.2. Exposure controls
Remove contaminated, saturated clothing immediately. Draw up and observe skin protection
programme. Wash hands and face before breaks and after work and take a shower if necessary.
When using do not eat or drink.
programme. Wash hands and face before breaks and after work and take a shower if necessary.
When using do not eat or drink.
Protective and hygiene measures
Suitable eye protection: goggles.
Eye/face protection
When handling with chemical substances, protective gloves must be worn with the CE-label including
the four control digits. The quality of the protective gloves resistant to chemicals must be chosen as a
function of the specific working place concentration and quantity of hazardous substances. For special
purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned
above together with the supplier of these gloves.
Suitable material: NBR (Nitrile rubber), FKM (fluoro rubber), PVC (Polyvinyl chloride)
Thickness of the glove material: > 0,5 mm
the four control digits. The quality of the protective gloves resistant to chemicals must be chosen as a
function of the specific working place concentration and quantity of hazardous substances. For special
purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned
above together with the supplier of these gloves.
Suitable material: NBR (Nitrile rubber), FKM (fluoro rubber), PVC (Polyvinyl chloride)
Thickness of the glove material: > 0,5 mm
Hand protection
Wear suitable protective clothing.
Skin protection
In case of inadequate ventilation wear respiratory protection.
Combination filtering device (EN 14387): A-P2
Combination filtering device (EN 14387): A-P2
Respiratory protection
light yellow
liquid
Physical state:
Colour:
Colour:
9.1. Information on basic physical and chemical properties
SECTION 9: Physical and chemical properties
characteristic
Odour:
Test method
pH-Value:
not determined
Changes in the physical state
not determined
Melting point:
> 200 °C
Initial boiling point and boiling range:
> 200 °C
Flash point:
Revision date: 02.04.2014
GB - EN