Техническая Спецификация для Reely RC model helicopter RtF 150 1195426

The two flight batteries are charged with the enclosed USB charging adapter. For this, the adapter is connected to a

USB socket of a computer/notebook or a commercial USB plug-in mains adapter with the also-enclosed USB cable. 

 

Do not connect the USB cable to a USB hub without a separate mains adapter (e.g. a keyboard USB port, 

etc.), because these will not provide sufficient current for charging.

Connect the flight batteries (1) to the connection sockets pro-

tected against polarity reversal of the charging adapter (2) ac-

cording to the adjacent figure. Work with the required care and

do not apply any unnecessary force. Then connect the minia-

ture USB plug (small plug) of the USB cable (3) to the charging 

adapter according to the figure.
Once you connect the USB plug (large plug) of the USB cab-

le to a USB socket of a computer/notebook or a USB plug-in 

mains adapter, charging commences.
Each charging output has its own LED display (4), which lights 

up red while charging. When charging is completed, the display 

of the charge indicator LED switches from red to green.

  Disconnect the rechargeable batteries from the charging adapter right after charging and pull the USB plug 

from the computer/notebook or plug-in charger. 

The two charging chutes above the LED displays (see fig. 7, item 5) may be used if needed to charge

rechargeable batteries of other small models with the corresponding plug-in socket. In connection with the 

model helicopter „HCP80“, however, the charging chutes are not needed.

 

Only charge one rechargeable battery per side (shaft or cable connection). Never try charging two rechar-

geable batteries (shaft and cable connection) on one side of the charging adapter at once!

Place the flight batteries and the charging adapter on a fire-proof underground when charging and do not

charge the battery unsupervised.

When connecting the charging cable to a computer/notebook, the operating system will not recognise any new hard-

ware, since the USB connection is only used for charging. 
Please observe that the USB ports of your computer/notebook are usually only active when the computer/notebook is 

switched on. Therefore, we recommend to only connect the charging cable to a computer/notebook that is switched 

on.