Техническая Спецификация для Numark DJ Controller NV 102764
Модели
102764
4
Mixer Controls
4.
Gain Trim: Adjusts the pre-fader, pre-EQ audio level of the corresponding channel in the
software.
software.
5.
LED Meters: Monitors the audio levels of the corresponding channel.
6.
Channel Treble: Adjusts the high (treble) frequencies. When Touch Mode is activated,
touching this knob will mute the corresponding channel's high frequencies (an "EQ kill").
touching this knob will mute the corresponding channel's high frequencies (an "EQ kill").
7.
Channel Mid: Adjusts the mid-range frequencies. When Touch Mode is activated,
touching this knob will mute the corresponding channel's mid-range frequencies (an "EQ
kill").
touching this knob will mute the corresponding channel's mid-range frequencies (an "EQ
kill").
8.
Channel Bass: Adjusts the low (bass) frequencies. When Touch Mode is activated,
touching this knob will mute the corresponding channel's low frequencies (an "EQ kill").
touching this knob will mute the corresponding channel's low frequencies (an "EQ kill").
9.
Channel Fader: Adjusts the audio level on the corresponding channel in the software.
10.
PFL: Press this button to send this channel's pre-fader signal to the Cue Channel for
monitoring. When engaged, the button will be lit. By pressing one PFL button at a time,
you will cue that channel alone (and deactivate PFL monitoring for the other channels). To
cue to multiple channels simultaneously, press the PFL buttons for those channels at the
same time.
you will cue that channel alone (and deactivate PFL monitoring for the other channels). To
cue to multiple channels simultaneously, press the PFL buttons for those channels at the
same time.
11.
Crossfader Assign: Routes the audio playing on the corresponding channel to either
side of the crossfader (A or B), or bypasses the crossfader and sends the audio directly
to the Program Mix (center, Off).
to the Program Mix (center, Off).
12.
Crossfader Slope: Adjusts the slope of the crossfader curve. Set the switch to the left for
a smooth fade (mixing) or to the right for a sharp cut (scratching).
13.
Fader Start: Enables or disables "fader start" on the corresponding side of the
crossfader. When fader start is enabled on one side, moving the crossfader toward that
side will cause the Deck to start playing.
side will cause the Deck to start playing.
14.
Crossfader: Blends audio between the channels assigned to the left and right side of the
crossfader.
15.
Master Volume: Adjusts the output volume of the Program Mix.
16.
Booth Volume: Adjusts the output volume of the Booth Output mix.
17.
Mic/Aux On/Off: When set to Mic, the Mic Input is active, and its audio signal is routed
directly to the Program Mix. When set to Off, the Mic Input and Aux Input are disabled.
When set to Aux, the Aux Input is active, and its audio signal is routed directly to the
Program Mix.
When set to Aux, the Aux Input is active, and its audio signal is routed directly to the
Program Mix.
18.
Mic/Aux Gain: Adjusts the gain of the Mic Input and Aux Input.
19.
Mic Tone: Adjusts the brightness or darkness of the microphone input signal.