Техническая Спецификация для Mc Crypt MP-5000 POWER AMPLIFIER MP-5000
Модели
MP-5000
26
Connection
The power amplifier has cinch sockets and symmetrically connected XLR inputs.
The connections selected do not affect function. Only use one connection type at a time, though.
The power amplifier has stable screw terminals for speaker connection.
The connections selected do not affect function. Only use one connection type at a time, though.
The power amplifier has stable screw terminals for speaker connection.
Only use suitable shielded XLR or cinch cables for connection to inputs. Using other cables
may lead to interferences.
may lead to interferences.
To avoid distortion or mismatches that may damage the device, the XLR inputs must only be
connected to sources with an XLR output and the cinch inputs only to sources with a cinch
output.
connected to sources with an XLR output and the cinch inputs only to sources with a cinch
output.
Connection to the speakers must be two-wire each. Insulate any open connection points. Make
sure that the cables are not damaged by sharp edges.
sure that the cables are not damaged by sharp edges.
Only use speakers with sufficient load capacity (see “Technical Data”).
Connect the speakers directly to the power amplifier. Do not use any headphones or junction
boxes! If in doubt, contact a specialist.
boxes! If in doubt, contact a specialist.
Observe that all speakers have the correct polarity - that is, that plus and minus marks match.
The power amplifier was developed for operation with speaker impedances of at least 4 Ohm.
Never connect speakers with a lower impedance.
Never connect speakers with a lower impedance.
Also observe the connection values in the chapter “Technical Data”.
a) Connection of the In- and Outputs
• Connect the outputs of your audio source (mixer, equalizer, etc.) to the corresponding inputs of the power
amplifier.
Connect the left channel to the corresponding input socket LINE IN CH1 (4 or 5). Connect the right
channel to the corresponding input socket LINE IN CH2 (4 or 5).
channel to the corresponding input socket LINE IN CH2 (4 or 5).
• Connect the left speaker to the speaker output POWER OUT CH1 (6). Connect the right speaker to the speaker
output POWER OUT CH2 (6).
Connect the plus pole of the speaker to the red speaker output terminal and the minus pole of the
speaker to the black speaker output terminal.
speaker to the black speaker output terminal.