Техническая Спецификация для Renkforce MP 2000 MP-2000

Модели

MP-2000

9. Operation

After connection and verification of the cables, you can take the power amplifier into operation for the

first time.

Only take the power amplifier into operation after familiarising yourself with its functions and

these operating instructions. Check again that all connections are correct.

Make sure that the amplifier and the connected devices are not overloaded. Playback must
never be distorted. If distorted music signals can be heard although the volume was not set too
high, switch off the system immediately and check the connection. If the connection is correct,
please contact a specialist.

• Turn the LEVEL (2) controller to minimum (left stop).
• Switch on your audio source (e.g. mixer) and the connected devices.
• Switch on the amplifier with the POWER (1) mains switch (switch in “I” position).
• Set the audio source volume to approx. 75% of the maximum volume or the maximum undistorted level

(visible for devices with level indicator at the 0 dB mark).

• Now set the maximum required volume with the LEVEL (2) volume controls.

This setting achieves the highest possible signal-to-noise ratio and enables the best audio quali-

ty. Note that the maximum volume depends on the performance of the speakers and the amplifier.

Playback must never be distorted. If the volume is too high, this may lead to damage to the spea-

kers as well as the amplifier.

• After completing this setting, the volume will only be controlled via the volume control at the audio sour-

ce (mixer) anymore.

• To switch off the system, first switch off the amplifier with the POWER (1) mains switch and then the

audio sources.

The amplifier for this equipment should always be the last to be turned on and the first to be

turned off. This will prevent any undesired noises (which can typically occur when switching
off the device) from damaging the amplifier or loudspeakers.