Техническая Спецификация для Velleman 3D printer assembly kit Single extruder (value.974113) K8200

@

velleman_RnD

In the 3D window will appear the outlines of the PCB tracks that will be made by milling (Show Filament and Show 

route must be operative). From G -Code Editor delete the initial lines in which there are round brackets (in this 

case only the second command line).

Click on the dropdown menu of G -Code Editor and select “initial code” .
Enter the initial GCode shown in the picture below:

G92 X0 Y0 Z0; offset of the coordinate system , set X0 Y0 Z0 as a starting point; G01 F500;linear movement 

with speed of 500 mm/min

then click the disk icon to save it.

Now select “Final G-code”,enter 

G01 X0 Y0 F500

; back to X0 Y0 position with linear movement of 500 mm/min 

and save it.

These changes are needed to define the offset of the coordinate system so that the machine operates in the 

desired area and back to the starting point when processing is finished.