Техническая Спецификация для Velleman K8071 High Power LED Driver Kit K8071

4 

Assembly hints 

1. Assembly  (Skipping this can lead to troubles ! ) 
Ok, so we have your attention.  These hints will help you to make this project successful.  Read them carefully. 
 
1.1 Make sure you have the right tools: 
 

• 

A good quality soldering iron (25-40W) with a small tip. 

 

• 

Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look.  This is called ‘thinning’

 and will 

protect the tip, and enables you to make good connections.  When solder rolls off  the tip, it needs cleaning. 

 

• 

Thin raisin-core solder.  Do not use any flux or grease. 

 

• 

A diagonal cutter to trim excess wires.  To avoid injury when cutting excess  leads, hold the lead so they  
cannot fly towards the eyes. 

 

• 

Needle nose pliers, for bending leads, or to hold components in place. 

 

• 

Small blade and Phillips screwdrivers.  A basic range is fine. 

 

⇒ 

Make sure the skill level matches your experience, to avoid disappointments. 

⇒ 

Follow the instructions carefully.  Read and understand the entire step before you perform each operation.  

⇒ 

Perform the assembly in the correct order as stated in this manual 

⇒ 

Position all parts on the PCB (Printed Circuit Board) as shown on the drawings.  

⇒ 

Values on the circuit diagram are subject to changes. 

⇒ 

Values in this assembly guide are correct* 

⇒ 

Use the check-boxes to mark your progress. 

⇒ 

Please read the included information on safety and customer service 

 

* Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaflet.  

 

0.000