Техническая Спецификация для Siemens MICROMASTER 420 0.37 kW 1-phase frequency inverter, 230 Vac to , 6SE6420-2AB13-7AA1 6SE6420-2AB13-7AA1

MICROMASTER 420 Operating Instructions

31

6SE6400-5AA00-0BP0

Hz

P(1)

r

0000

Indicates Status

The LCD displays the settings currently used by
the converter.

Start converter

Pressing the button starts the converter. This button
is disabled by default. To enable this button set
P0700 = 1.

Stop converter

OFF1 Pressing the button causes the inverter to

come to a standstill at the selected ramp
down rate. Disabled by default, to enable set
P0700 = 1.

OFF2 Pressing the button twice (or once long)

causes the motor to coast to a standstill.

Change direction

Press this button to change the direction of rotation
of the motor. Reverse is indicated by a minus (-)
sign or a flashing decimal point. Disabled by default,
to enable set P0700 = 1.

Jog motor

Pressing this button while the inverter has no output
causes the motor to start and run at the preset jog
frequency. The inverter stops when the button is
released. Pressing this button when the
inverter/motor is running has no effect.

Functions

This button can be used to view additional
information. See also Section 5.1.2 on page 44.

It works by pressing and holding the button. It
shows the following, starting from any parameter
during operation:
1.  DC link voltage (indicated by d).
2.  output current. (A)
3.  output frequency (Hz)
4. output 

voltage 

(o).

5.  The value (selected in P0005).

Access parameters

Pressing this button allows access to the
parameters.

Increase value

Pressing this button increases the displayed value.
To change the Frequency Setpoint via the BOP set
P1000 = 1.

Decrease value

Pressing this button decreases the displayed value.
To change the Frequency Setpoint via the BOP set
P1000 = 1.

Figure 3-3

Buttons on the Basic Operator Panel