Техническая Спецификация для Buffalo TeraStation 1200 TS1200D0602-EU
Модели
TS1200D0602-EU
82
Changing the IP Address
Normally, the TeraStation's IP address is set automatically from a DHCP server on your network. If you prefer, you can
set it manually. An easy way to do this is to change it from NAS Navigator2 running on a computer connected to the
same router (subnet) as the TeraStation. The procedure to change the IP address in Settings is below.
set it manually. An easy way to do this is to change it from NAS Navigator2 running on a computer connected to the
same router (subnet) as the TeraStation. The procedure to change the IP address in Settings is below.
1
In Settings, click Network.
2
Click
to the right of "IP Address".
3
Click the LAN port where the IP address will be changed.
4
Disable "DHCP" and enter the desired network address settings, then click OK.
Note: The following IP addresses are reserved and should not be used. If you configure one of them by accident,
initialize IP address settings with the function button on the TeraStation.
initialize IP address settings with the function button on the TeraStation.
Local loopback address: 127.0.0.1, 255.255.255.0
Network address: 0.0.0.0, 255.255.255.0
Broadcast address: 255.255.255.255, 255.255.255.0
The IP address range from 224.0.0.0 to 255.255.255.255
Network address: 0.0.0.0, 255.255.255.0
Broadcast address: 255.255.255.255, 255.255.255.0
The IP address range from 224.0.0.0 to 255.255.255.255