Техническая Спецификация для Buffalo TeraStation 1200 TS1200D0602-EU
Модели
TS1200D0602-EU
93
Information Code
Description
Corrective Action
I33
An error occurred in replication,
or synchronization between the
main TeraStation and the backup
TeraStation failed during the replication
configuration.
or synchronization between the
main TeraStation and the backup
TeraStation failed during the replication
configuration.
In Settings, navigate to Backup -
Replication and click Resync to execute
resynchronization. If the error is
displayed again, contact Buffalo
technical support for assistance.
Replication and click Resync to execute
resynchronization. If the error is
displayed again, contact Buffalo
technical support for assistance.
I37
System recovery in progress.
-
I38
System recovery is complete.
-
I41
Press the function button on the front to
start the recovery process.
start the recovery process.
-
I42
Preparing to start the recovery process.
-
I45
Recovery failed.
-
I46
Data migration or conversion (RAID
migration) is in progress.
migration) is in progress.
Don't turn off the TeraStation.
I47
Data migration or conversion (RAID
migration) is in progress.
migration) is in progress.
Don't turn off the TeraStation.
I52
A new firmware version has been
released.
released.
Update the firmware.
I54
A backup job has failed.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If
the backup job still fails to run correctly,
check the status of the NAS, network,
and backup source and destinations.
configured correctly. Make sure that the
NAS is on and not in standby mode. If
the backup job still fails to run correctly,
check the status of the NAS, network,
and backup source and destinations.
I55
Authentication during recovery of
settings failed.
settings failed.
Settings can only be restored for the
TeraStation whose settings were
originally saved. To restore settings,
insert the USB memory device, turn
on the TeraStation while holding
down the init button on the rear of the
TeraStation, and restart the TeraStation.
Or, settings can be restored in Settings
with the TeraStation powered on.
TeraStation whose settings were
originally saved. To restore settings,
insert the USB memory device, turn
on the TeraStation while holding
down the init button on the rear of the
TeraStation, and restart the TeraStation.
Or, settings can be restored in Settings
with the TeraStation powered on.
Amber (Not Blinking)
When the power LED glows a steady amber, a new firmware version is available. Update the firmware to the newest
version.
version.
Default Settings
Administrator's Name
admin
Password
password
Shared Folders
"share" (for both Windows and Mac computers). The recycle bin is enabled
on "share" by default.
on "share" by default.
DHCP Client
Normally, the TeraStation will get its IP address automatically from a DHCP
server on the network. If no DHCP server is available, then an IP address
will be assigned as follows:
IP address: 169.254.xxx.xxx (xxx is assigned randomly when booting the
TeraStation.)
Subnet mask: 255.255.0.0
server on the network. If no DHCP server is available, then an IP address
will be assigned as follows:
IP address: 169.254.xxx.xxx (xxx is assigned randomly when booting the
TeraStation.)
Subnet mask: 255.255.0.0
Registered Groups
"hdusers", "admin", and "guest" are default groups and cannot be edited or
deleted.
deleted.