Справочное Руководство для TP-LINK TL-SG2008

 

150

 

The snmp-server traps command is used to enable SNMP extended traps. To 

disable the sending of SNMP extended traps, please use no snmp-server 

traps command. 

snmp-server traps { bandwidth-control | cpu | flash | ipaddr-change | 

loopback-detection | storm-control | spanning-tree } 

no snmp-server traps { bandwidth-control | cpu | flash | ipaddr-change | 

loopback-detection | storm-control | spanning-tree } 

bandwidth-control —— Enable bandwidth-control trap. It is sent when the rate 

limit function is enabled and the bandwidth exceeds the predefined value. 

cpu —— Allow CPU-related trap. It is sent when CPU usage exceeds the 

predefined threshold. By default, the CPU usage threshold of the switch is 80%.   

flash —— Enable flash trap. It is sent when flash is modified during operations 

such as backup, reset, firmware upgrade, configuration import, etc.   

ipaddr-change —— Enable ipaddr-change trap. It is sent when IP address is 

changed such as user manually modifies the IP address or the switch obtains a 

new IP address from DHCP. 

loopback-detection —— Enable loopback-detection trap. It is sent when the 

switch detects loopback or loopback is cleared. 

storm-control —— Enable storm-control trap. It is sent when the multicast or 

broadcast rate exceeds the predefined value. 

spanning-tree —— Enable spanning-tree trap. It is sent when the port 

forwarding status changes or the port receives TCN packet or packet with TC 

flag. 

Global Configuration Mode 

Enable SNMP extended bandwidth-control trap for the switch: 

TL-SG2008(config)# snmp-server traps bandwidth-control