Техническая Спецификация для Samsung BN59-01012A
Material Safety Data Sheet
5. FIRE-FIGHTING MEASUARES
FLAMMABLE PROPERTIES: Not highly flammable
FLASH POINT: No data available
FLAMMABLE LIMITS
LEL:No data available
UEL:No data available
EXTINGUISHING MEDIA: Water fog, foam, CO２, dry chemical.
FIRE-FIGHTING EQUIPMENT: Wear full bunker gear including a positive pressure self-contained breathing
apparatus in case of burning in large quantities.
FIRE-FIGHTING EQUIPMENT: Wear full bunker gear including a positive pressure self-contained breathing
apparatus in case of burning in large quantities.
6. ACCIDENTAL RELEASE MEASURES
Minimize the release of particulates. Wear personal protective equipment.
Do not use vacuum cleaner.
After by lightly spraying with water to prevent development of dust, spills should be swept up or wiped up. Then
residuals can be removed with soap and water. Preferred to use the material in a place, covering up the floor and
surrounding matters with suitable sheets such as paper, in a case of being not fit to scrub the floor with water.
residuals can be removed with soap and water. Preferred to use the material in a place, covering up the floor and
surrounding matters with suitable sheets such as paper, in a case of being not fit to scrub the floor with water.
These used sheets should be wrapped up in spills and transfer into a suitable container for disposal.
Garments may be washed or dry cleaned, after removal of loose toner.
7. HANDLING AND STORAGE
Avoid creating dust. Clean up all spills promptly.
Inhalation and contact with skin or eyes should be avoided.
Provide general ventilation. Good general ventilation should be sufficient for most conditions.
Store in a cool, well ventilated place away from flames and spark-producing equipment.
May toners be preferred to use or to handle at the suitable place without concerning about smudges to which
are given rise by releasing them.
May toners be preferred to use or to handle at the suitable place without concerning about smudges to which
are given rise by releasing them.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Control parameters
OSHA PEL:
TWA 5.0mg/m
3
(Inert of Nuisance Dust:Respirable fraction)
15.0mg/m
3
(Inert of Nuisance Dust:Total dust)
ACGIH TLV:
TWA (2005)
3.0mg/m
3
(Particulates Not Otherwise Classified:Respirable Particle Mass)
10.0mg/m
3
(Particulates Not Otherwise Classified:Inhalable Particle Mass)
RESPIRATORY PROTECTION: For most conditions, no respiratory protection should be needed; however, in
dusty atmospheres, use an approved dust respirator.
SKIN PROTECTION:
No precautions should be needed under normal use.
EYE PROTECTION:
No precautions should be needed under normal use.
9. PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE:
Black fine powder
ODOR:
Odorless
BOILING POINT:
N.A.(not applicable)
VAP PRESS:
N.A.
VAP DENSITY:
N.A.
SOL IN WATER:
Negligible
SP. GRAVITY:
ca. 1.20
MELTING POINT:
N.A.
pH:
N.A.
% VOLATILE:
N.A.