Справочник Пользователя для Western Digital ShareSpace 2TB WDA4NC20000E

WD ShareSpace | 3

The power button turns the device on or off. To turn on the device, press the power button and hold down until 
the LED flashes once, then release. The LED remains off (up to 30 seconds) as the device powers up. Holding 
the button down for four seconds powers off the device.

You must set up your network storage system so it can be discovered on the network to which your computer is 
attached. Follow the steps below to configure your network storage system and map a network drive in 
Windows 2000/XP/Vista. Skip to page 5 for Mac instructions.

1. Turn on your computer and wait for the operating system to load.

2. Insert the software CD into the CD-ROM drive.

Note: If AutoPlay is disabled on your computer, you must install the utilities manually. Click Start and 
point to Computer (Windows Vista) or My Computer, then double-click Setup.exe in the root directory 
of the CD.

3. Windows Vista: Click Run setup.exe, then click Allow.

4. Click Accept in the Terms of Agreement screen.

5. If you have connected the device properly as shown in the Connect screen, click Next.

6. The Application Installer screen displays a list of options including software, documentation, and a 

registration link. All applications are selected by default. Deselect any applications you do not want to 
install, then click Start. Or, click Cancel to exit and no applications will be installed.

7. The WD Discovery™ screen appears. Click on WDShareSpace in the Network Drives Found list and point 

to and click Configure.

Important:  The device powers on automatically upon initial connection to power, which may take up to 
three minutes. During this time, do not press the power button.