Справочник Пользователя для Honeywell Limit switch 125 Vac 10 A Tappet momentary 2LS1-4PG IP67 1 pc(s) 2LS1-4PG

Plug switch into an 18PA1 terminal block, tighten

two screws and mounting is complete. Installation
of 18PA1 terminal block (purchased separately) is
covered in instructions which are packed with the

block.

Two simple methods of mounting: (a) use four 

10

screws from the front, or (b) use four ¼-20 UNC

screws from the back. Make sure conduit connection

is sealed. Locate switch so condensate or oil won’t

drain into switch through conduit.

For "7LS" cavity mount type use four # 10 screws

to fasten the switch plate to the surface. A rubber

gasket seals the plate to the mounting surface.

Use copper, 60/75 degree C wire only.

Terminal screw torque-20 inch pounds max.

COMPACT LS WITHOUT ACTUATOR

Actuator Head

Positioning Lever

To give flexibility in
application, the actu-

ator head may be posi-
tioned in any of four

directions.

(See                   

NOTICE

in "Direction of Actuation".)

The lever assembly is ad-
justable to any position
through 360° by loosening

the socket head screws.
A 

5/32 

inch hexagon key

wrench is required (avail-
able in "Handy Adjusting
Tool Set" 15PA53).

The roller arm may be reversed to face the roller

inside or outside of the arm.