Справочник Пользователя для Graupner Hendheld RC 2.4 GHz No. of channels: 5 33110

121

wish to use the RX CURVE option - then two curves 
must be set:

If you ignored this, the left and right ailerons would 
exhibit different control characteristics.
The RX CURVE function can be used to manage the 
control characteristics for up to three servos:

Select the desired control channel (INPUT CH) for 
the fi rst servo.
The following setting in TYPE only affects the chan-
nel you select at this point.
TYPE
Select the servo curve:
A: EXPO = -100% and DUAL RATE = 125% 
The servo responds slowly to stick movements 
around the neutral position, but the curve becomes 
steeper with increasing control travel.
B: Linear setting 
The servo follows the stick movement with a linear 
response.
C: EXPO = +100% and DUAL RATE = 70%
The servo responds slowly to stick movements 
around the neutral position, but the curve becomes 
steeper with increasing control travel.

ALL-MAX

Servo travel on 
the “+” side for all 
servo outputs in 
the servo test

1500 … 2000 μs

ALL-MIN

Servo travel on 
the “-” side for all 
servo outputs in 
the servo test

1500 … 1000 μs

TEST

Test procedure

START / STOP

ALARM 
VOLT

Alarm limit for the 
receiver low-
voltage warning

3,0 … 6,0 V
Default setting: 
3,8 V 

ALARM 
TEMP+

Alarm limit for 
excessive receiver 
temperature

50 … 80 °C
Default setting: 
70 °C

ALARM 
TEMP–

Alarm limit for 
excessively 
low receiver 
temperature

-20 … +10 °C
Default setting: 
-10 °C

CH OUTPUT 
TYPE

Channel sequence ONCE, SAME, 

SUMI, SUMO

ALL MAX (maximum servo travel)
In this line you can set the maximum servo travel for the 
servo test on the plus side of control travel.
2000 μs corresponds to full travel, 1500 μs corresponds 
to the neutral position.

ALL MIN (minimum servo travel)
In this line you can set the maximum servo travel for the 
servo test on the minus side of control travel.
1000 μs corresponds to full travel, 1500 μs corresponds 
to the neutral position.

TEST
In this line you can start and stop the receiver’s integral 
servo test.
Press the 

 button to activate the input fi eld:

Now select 

 with one of the arrow buttons of the 

right-hand four-way button:

Press the 

 button to start the test-run. The 

input fi eld now reverts from highlighted to “normal”: