Техническая Спецификация для Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075

● Select the function name 

and return to the Model 

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

The angle and curve of each stick function can be set. [All model types]

Dual rate function is used to adjust the amount 

of throw and the operational curve of the stick 

functions (aileron, elevator and rudder) for each 

flight condition or up to 5 rates for each function. 

For airplane type, it is also possible to adjust the 

operational curve of the throttle function.

This is normally used after the End Point 

programming has been completed to define the 

maximum throw. When mixing is applied from one 

channel to another channel, both channels can be 

adjusted at the same time by adjusting the operation 

rate through the dual rate function.

Neutral position of the dual rate curve can be 

set. 

Dual rate curve of FLAP, FLAP3, BUTTERFLY, 

and CAMBER function can be set. (Airplane/

Glider)

*FLAP3 and BUTTERFLY are glider only functions.
* E X P  r a t e   s e t t i n g   i s   n o t   a l l o w e d   i n   t h e   F L A P, 

FLAP3,BUTTERFLY, and CAMBER functions.

*Individual switch setting is not allowed in the FLAP,FLAP3, 

and  BUTTERFLY,  CAMBER  functions.  (Condition 

switching only)

● Select [DUAL RATE] at the Model menu and access 

the setup screen shown below by touching the 

RTN button.

(Currently selected circuit #)

●Neutral position

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

●Left/right (up/down) rate

●Operation curve (left/right, up/down)

●Switch selection

[Airplane]

[Helicopter/glider]

●Condition Mode 

selection

●Switch mode 

selection

●Condition selection

●Switch selection

*Up to five rates for each function

●Function selection