Техническая Спецификация для Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075

The screens shown below are curves created by 

entering the pitch rate at low, center, and high side (3 

points or 5 points) at each condition. 

When actually creating a curve, input the rate 

specified by the model (or the reference value).

[Hovering pitch trim setting]

The Hovering Pitch trim function trims the pitch 

near the hovering point. Normally, it is used with 

the hovering condition. The hovering pitch can be 

fine tuned for changes in rotor speed accompanying 

changes in temperature, humidity, and other flight 

conditions. Adjust the hovering pitch so that 

rotor speed is constant. This function can be used 

together with the Hovering Throttle Trim function 

for more precise operation.

● Set the function to ACT [ON]. (initial setting)
● Select the adjustment knob.
 Selection example: LD (initial setting)
●  The  trim  operation  mode  (Mode:  CTRM/

NORM) can be selected.

 CTRM mode: Maximum amount of change

near  center  by  center  trim  operation

(recommended)

 N O R M   m o d e :   N o r m a l   t r i m   ( p a r a l l e l

movement trim) operation. The advantage

of using this mode is that the hovering pitch

can  be  adjusted  without  changing  the

curve.

●  The  trim  rate  can  be  adjusted  and  the

operation direction can be changed.

● Trim adjustment range (Range) setting
 When this value is made small, trim can only

be used near the center.