Техническая Спецификация для Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075

Модели

1-F8075

<Functions of Linkage Menu>

● Select the function name

and return to the Linkage

menu by touching the

R T N b u t t o n . 　 O r t h e

H O M E / E X I T b u t t o n i s

pushed.

<SensorTouch™>

RETURN

IDLE DOWN

Lowers the engine idling speed.(airplane only)

The Idle Down function lowers the engine to

its idle position. Like Throttle Cut, this is usually

accomplished by flipping a switch with the throttle

stick at idle. The action is not functional at high

throttle to avoid accidental dead sticks. The

switch’s location and direction must be chosen, as

it defaults to NULL.

Idle down setting procedure

1. Activate the function:
Move the cursor to the [ACT] item and touch

the RTN button to switch to the data input

mode.

Select the ACT mode by scrolling the touch

sensor.

*The display blinks.

Touch the RTN button to activate the

function and return to the cursor mode.

2. Switch selection:
Move the cursor to the [SW] item and access

the switch setup screen by touching the RTN

button. Select the switch and ON direction.

*For a detailed description of the setting method, see [Switch

Setting Method] at the back of this manual.

3. Offset rate setting:
Move the cursor to the [OFFSET] item and

touch the RTN button to switch to the data

input mode.

Adjust the servo offset rate at idle down

operation by scrolling the touch sensor.

Initial value: 0%
Adjustment range: -100%~0%~+100%

* When a minus rate is input, an offset is applied at the high

side.

*Maximum offset amount is near maximum slow.

* When the RTN button is touched for one second, the offset

rate is reset to the initial value.

Touch the RTN button to end the adjustment

and return to the cursor mode.

● Select [IDLE DOWN] in the Linkage menu and

access the setup screen shown below by touching

the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● Current throttle position