Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

Ex works, your remote control „HT-6“ is configured so that the control lever for the throttle/pitch function is on the

left. This is the most common configuration in Europe. If you prefer to have the throttle/pitch function on the right as

opposed to the left stick, you have the option of swapping the two stick units with each other.
To make the necessary changes, some experience with remote control transmitters is required. Therefore you should 

consult an experienced model maker or a model construction club if you do not feel capable of undertaking the pro-

cedures described in the following. 
•  Remove the transmitter batteries.
•  Unscrew the four screws by means of a Phillips-tip screwdriver from the rear panel of the transmitter and lift the rear

panel carefully towards the left. 

•  On demand, you can disconnect the supply lines of the battery box and the teacher/student socket (1) at the main

PCB.

•  For this, loosen the four screws at the control stick units and swap the two units (fig. 6A, item 2). You need to turn

the control stick units by 180° each so that the connections of the control stick potentiometers (3) are aligned to the 

inside again (see fig. 6B).

•  Screw on the control stick units again and check the mechanical function of the control sticks.
•  Connect the battery box and the teacher/student box to the main PCB.
•  Attach the transmitter back wall again and turn in the four attachment screws again.

 The electronic modification of the throttle function is done later in the System setting menu under „Sticks

mode“.