Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

*  Electric models with an electronic flight controller only require a separate rechargeable receiver battery if the

flight controller used does not have a BEC circuit. For further information, refer to the technical documents of the

controller.

Channels  5  and  6  can  be  assigned  differently  depending  on 

model. There also is the option of operating two servos via a 

V-cable at a receiver output. 
For a possible setup or distribution of the control channel, see 

the adjacent sketches in figure 9.
If a model is equipped, e.g. with two aileron servos, the second 

servo can be connected to a receiver output that has not been 

assigned yet. The control is then performed via one of the three 

freely programming mixers. 
For more information on the servo connection and the mixing 

functions, see the following chapters (programing of the remote 

control transmitter) in the respective function. 

 

It is recommended to use a pair of tweezers or long-nosed pliers to disconnect the connection. To prevent 

cable breaks, you should always pull on the plastic casing of the plug to disconnect the connection. Never 

pull on the cables.

The receiver has an LED display that serves mainly as an indicator for the receiver condition on one side (see figure

8, item 2). 
The LED is lit only when the transmitter is on and bound to the receiver in operation of the receiver. If the transmitter 

does not recognise any valid transmitter signal, the LED flashes. More information on the transmitter binding can be

taken from chapter: Binding Function.