Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

As described previously for the receiver connection, the individual receiver outlets (channels) have specific functions

or servos assigned to them. The first four outputs are assigned as follows:
CH1 = channel 1 (aileron/roll servo)
CH2 = channel 2 (elevator/nod servo)
CH3 = channel 3 (throttle servo/flight controller)
CH4 = channel 4 (rudder/tail servo)
When  setting  the  control  stick  assignment,  you  can  exactly 

determine the control stick you want to use to control outputs 

1 - 4.
Setting the control stick assignment:
•  Switch on the transmitter and call the system setting menu.
•  Move the cursor arrow to the menu item „Sticks mode“ with the

two buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The  display  shows  the  currently  used  control  stick  assign-

ment. The two circles with the lines offset by 90° are the two 

control sticks. Additionally, the control functions are displayed 

according to the control stick assignment.

•  Pushing the buttons „UP“ or „DOWN“ permits setting the desi-

red control stick assignment „Mode 1“ to „Mode 4“.

•  Keep the button „CANCEL“ pushed for a longer period to save

the settings. The display then shows the system setup menu 

again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display. 

  Please observe that the control sticks are designed for „Mode 

2“ or „Mode 4“ ex works. If you prefer „mode 1“ or „mode 3“, 

the stick units must be swapped.