Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state, 

transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed 

mainly after a replacement of the transmitter or receiver or to remove any interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see „RX 

setup“ in the system settings menu).
To perform the binding procedure, proceed as follows:
•  Transmitter and receiver must be in direct proximity (distance

approx. 50 cm).

•  Switch off the transmitter.
•  Disconnect any servos that may be connected from the recei-

ver.

•  Connect the enclosed programming plug (1) to the „B/VCC“

connection of the receiver. 

•  The power supply of the receiver (receiver battery or speed

controller with BEC) is connected to any output of the recei-

ver.

•  Switch on the receiver. The receiver LED (2) starts to flash

quickly.

•  Press the binding button at the receiver (see also figure 1, item

13) and keep the button pressed.

•  Switch on the transmitter with the on/off switch with the binding

button pushed. The display briefly shows „RXBinding“ and, at

correct binding, „RXBind OK“. Then the display switches to 

operating display.

•  The LED in the receive (2) now flashes slowly and the binding

process is completed.

•  Release the binding button at the transmitter.
•  Switch off the receiver and then the transmitter.
•  Remove the programming plug and connect the servos/controllers to the receiver again.
•  Check the function of the system.

  The receiver or the servos now must react to the control signals of the transmitter. If this is not the case, 

repeat binding or check the digital encoding of transmitter and receiver.