Техническая Спецификация для Iconnectivity ICONNECT MIDI2+ (EU) icm2-opt EU
Модели
icm2-opt EU
1
Power button
This switch has several functions.
• Putting the iConnectMIDI
2+
to sleep and waking it up.
Put the device to sleep by holding the button in for a couple of seconds until the green
LED (2) goes out, then releasing it.
LED (2) goes out, then releasing it.
Wake it up by touching it briefly.
• Hard-resetting the device.
Hold the button in for about seven seconds until all the LEDs light up, then release it.
• Putting the device into boot loader mode, ready to receive firmware updates.
Hold the button in for four seconds until the Power LED (2) turns red, then release it. The
MIDI 1 and MIDI 2 lights (3) will flash.
MIDI 1 and MIDI 2 lights (3) will flash.
To return to normal mode, put the device to sleep and wake it up as instructed above.
2
Power LED
This light turns green when the device is powered up normally, and red when it is about to
go into boot loader mode (ready to receive firmware updates). When the iConnectMIDI
go into boot loader mode (ready to receive firmware updates). When the iConnectMIDI
2+
is
in boot loader mode, the Power LED turns off and the MIDI 1 and 2 LEDs flash.
3
MIDI 1 and 2 LEDs
These lights indicate that data is MIDI data is being sent to or received from devices
plugged into the MIDI DIN ports on the rear. They also flash when the device is in boot
loader mode, and they flash along with all the other LEDs when the device starts up, and
also when a hard reset is about to start.
plugged into the MIDI DIN ports on the rear. They also flash when the device is in boot
loader mode, and they flash along with all the other LEDs when the device starts up, and
also when a hard reset is about to start.
4
USB Device port 1 and 2 LEDs
These lights indicate that MIDI data is being sent to or received from devices plugged into
the USB Device ports. They also light up along with all the other LEDs when the device
starts up, and when a hard reset is about to start.
the USB Device ports. They also light up along with all the other LEDs when the device
starts up, and when a hard reset is about to start.
9