Справочник Пользователя для Spektrum DX18 SPM18000

SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

The Throttle Cut menu option enables you assign a switch position 
to stop an engine or motor. Throttle Cut activates regardless of 
Flight Mode.
When you activate Throttle Cut, the throttle channel moves to the 
pre-programmed position (normally Off).  
You may need to use a negative value to move the Throttle chan-
nel to the off position.

Always test the model after making adjustments 

to make sure the model responds to controls as desired.

You can use the Throttle Curve menu option to optimize the 
throttle response. A maximum of 7 points are available on the 
throttle curve.   

To add points to a Throttle Curve:

1. Move the throttle stick to the position where you wish to add 

the new point.

2. Scroll to Add Pt. and press the scroll wheel to add the point.

To remove points from a Throttle Curve: 

1. Move the Throttle stick until the cursor is near the point you 

wish to remove.

2. Scroll to Remove Pt. and press the scroll wheel once to 

remove the point.

If you program multiple throttle curves and you wish to edit one 
of the curves, that curve must be active in the Throttle Curve 
screen before you can make any changes. 

The V-Tail Differential screen enables you to increase or 
decrease the amount of differential between control surface 
throws. 
Positive Differential values decrease the amount of “up” travel 
without affecting the “down” travel on the opposite control 
surface.
Negative Differential values decrease the amount of “down” 
travel without affecting the amount of “up” travel on the opposite 
control surface.
The V-Tail Differential menu option only appears when V-Tail A or 
V-Tail B is active in Aircraft Type.

To adjust the V-Tail Differential:

1. Scroll to Switch and press the scroll wheel. Scroll right to 

select On (Differential is always on) or assign the differential 
to a switch position.

2. Press the scroll wheel a second time to save the selection.
3. Scroll to Diff: and press the scroll wheel once to change the 

value.

4. Press the scroll wheel again to save the selection.