Справочник Пользователя для Jeti RC console 2.4 GHz No. of channels: 16 80001571

Модели

80001571

computer radio control system

Carefully remove both control stick assemblies. Gently pull in

your direction (toward the transmitter back side). This upgrade

will be done outside of the transmitter case.

Unscrew the upper part of the stick assembly (anticlockwise).

Insert the connecting wires through the hollow opening of the

transmitter stick.

Adjust length of the stick to suit your flying style. (See 4.3)

After installation of the optional stick ends with switch or
button; make sure that while adjusting the stick length

Note:

Remove both machine installation screws for each of the

control stick assemblies.

you observe the wires that pass through the stick shaft
and  through  the  gimbal  opening  in  order  to  prevent
damaging the connecting cables.   The safest method is
to  de-solder  the  stick  end  switch  control  wires  and
remove  them  from  the  gimbal  opening  during
adjustment.

Pass the switch wires through the same gimbal opening as the

hall sensor cable (through the center of the gimbal assembly).

10.

Next insert wire ends through the opening of the printed circuit

board and solder them to the matching soldering points in such

a way that the same color wires lay on the top of each other.

11.

Carefully move transmitter sticks to their full outside positions

in order to make sure that you have sufficient wire length and, if

needed, adjust accordingly. The connecting cables for all

moving parts of the unit should have sufficient length in order

not to be exposed to any mechanical damage and any bending

stresses.

12.

Install stick unit assembly back to correct position.

13.

Install and secure the machine screws for the control stick

assembly.