Справочник Пользователя для Jeti RC console 2.4 GHz No. of channels: 16 80001571
Модели
80001571
computer radio control system
EN
7 Initial switching-on
7.1 Main display
Turn the transmitter on by pressing and holding the „Power“ button
for a couple of seconds and then press the "F5 (Yes)" button to
confirm, see chapter 6.1. The display shows the Main screen and
displays the currently loaded model aircraft.
for a couple of seconds and then press the "F5 (Yes)" button to
confirm, see chapter 6.1. The display shows the Main screen and
displays the currently loaded model aircraft.
The main screen displays basic information about operation of your
transmitter, such as the battery level, time, flight mode, etc. This
screen will also display the user defined information you want to
monitor, for example: stopwatch, telemetry values, etc. The main
screen consists of three main sections: the status bar, the desktop
and the lower bar.
transmitter, such as the battery level, time, flight mode, etc. This
screen will also display the user defined information you want to
monitor, for example: stopwatch, telemetry values, etc. The main
screen consists of three main sections: the status bar, the desktop
and the lower bar.
1.
Signal strength
2.
Battery status
3.
Time
4.
Telemetry recording icon
5.
Model Name
6.
Name of actual flight
mode
The status bar at the top of the main display displays the following
information:
information:
3.
3.
The lower bar is found at the bottom of the main display.
The lower bar shows:
The lower bar shows:
1.
Opt.-fast transmitter set-up: Contrast, Telemetry,
Volume, Duration of Backliting, Backliting Brightness.
2.
Left Arrow-move left within the desktop pages.
3.
Arrow-move right within the desktop pages.
4.
Clr-resets timers
5.
Stop/Start-begin and end flight timer, triggering timers or
telemetry recording.
Use the corresponding F1-F5 buttons to select these options
From the main display you may access the main menu by pressing
the „menu“ button. To return from the main menu press either the
„menu“ or „esc“ button.
From the main display, when you push any of the trim buttons or the
3D button the „Trim menu” will be displayed.
Use the corresponding F1-F5 buttons to select these options
From the main display you may access the main menu by pressing
the „menu“ button. To return from the main menu press either the
„menu“ or „esc“ button.
From the main display, when you push any of the trim buttons or the
3D button the „Trim menu” will be displayed.
7
2
3
4
5
6
1
8
The Desktop is the largest part of the screen. This is where you can
see your telemetry data and where any programmed alarms are
displayed. The Desktop displays your user-defined information
through the use of multiple pages. As you add or remove telemetry
see your telemetry data and where any programmed alarms are
displayed. The Desktop displays your user-defined information
through the use of multiple pages. As you add or remove telemetry
items or alarms, the number of available pages will automatically
increase or decrease as needed.
In this example, the desktop page displays the following
information:
increase or decrease as needed.
In this example, the desktop page displays the following
information:
7.
Throttle Lock
8.
Motor cut-off indication, idle
1
2
3
4
5
23