Техническая Спецификация для Intel III M 866 MHz BXM80530B866512

 

 Mobile Intel

® 

Pentium

®

 III Processor in BGA2 and Micro-PGA2 Packages at 1 GHz,  

900 MHz, 850 MHz, 800 MHz, 750 MHz, 700 MHz, Low-voltage 750 MHz, Low-voltage  

700 MHz, Low-voltage 600 MHz, Ultra Low-voltage 600 MHz and Ultra Low-voltage 500 MHz 

283653-002 Datasheet 

13 

Performance improved over existing mobile processors 

—  Supports the Intel Architecture with Dynamic Execution 

—  Supports the Intel Architecture MMX™ technology 

—  Supports Streaming SIMD Extensions for enhanced video, sound, and 3D performance 

—  Supports Intel SpeedStep Technology 

—  Integrated Intel Floating Point Unit compatible with the IEEE 754 standard 

On-die primary (L1) instruction and data caches 

—  4-way set associative, 32-byte line size, 1 line per sector 

—  16-Kbyte instruction cache and 16-Kbyte write-back data cache 

—  Cacheable range controlled by processor programmable registers 

On-die second level (L2) cache 

—  8-way set associative, 32-byte line size, 1 line per sector 

—  Operates at full core speed 

—  256-Kbyte, ECC protected cache data array 

GTL+ system bus interface 

—  64-bit data bus, 100-MHz operation 

—  Uniprocessor, two loads only (processor and I/O bridge/memory controller) 

— Integrated 

termination 

Pentium II processor clock control 

—  Quick Start for low power, low exit latency clock “throttling” 

—  Deep Sleep mode for lower power dissipation 

Thermal diode for measuring processor temperature 

In this document a “#” symbol following a signal name indicates that the signal is active low. This 
means that when the signal is asserted (based on the name of the signal) it is in an electrical low 
state. Otherwise, signals are driven in an electrical high state when they are asserted. In state 
machine diagrams, a signal name in a condition indicates the condition of that signal being 
asserted. If the signal name is preceded by a “!” symbol, then it indicates the condition of that 
signal not being asserted. For example, the condition “!STPCLK# and HS” is equivalent to “the 
active low signal STPCLK# is unasserted (i.e., it is at 1.5V) and the HS condition is true.” The 
symbols “L” and “H” refer respectively to electrical low and electrical high signal levels. The