Справочник Пользователя для IFB Appliances AW60-806

SIMPLE INSTALLATION

After installation, do not start the washing machine in haste.  First open the tap to let the 

water press into the water inlet hose to check whether there is any leakage in the connectors 

on the both ends.  When the pressure is too high, please shut the tap a little to avoid water 

leakage.

            The method of  installation for the double water inlet hose is same. 

1. Nip the fixing ring with hand to make it loose 

and engaged on the drain  hose and put the 

drain hose into the leading skirt of drain hose in 

the bottom of the washing machine to the end 

at the most (soak the head of the drain hose in 

warm water, it will make the engagement easy), 

and loose the fixing ring to let it clasp the drain 

hose.

Step 5:

Cabinet

Fixing ring  

Leading ring

Drain hose

Inner hose

SIMPLE INSTALLATION AND SIMPLE OPERATION

Step 6:Power source and grounding

      The washing machine employs alternative current with the rated voltage and frequency.  When 

the voltage fluctuates between 10% of rated voltage, the washing machine can work normally.  A 

special power socket for the washing machine had better be set beside the washing machine for 

convenience and safety.  The method of connection of the socket is as the figure below:

Grounding wire

     The socket and the grounding wire must be installed 

by an electrician to prevent incorrect installation or use of 

the socket, and to guarantee the safety of use of 

electricity.

   The power wire of the washing machine employs Y 

connection and the replacement of the power wire 

should be carried out by professionals.

      No connection of the grounding wire with the neutral 

wire, otherwise the cabinet will be charged, which is 

likely to cause the danger of electric shock.

o

1. Slant the washing machine with angle of 45 in  the direction of 

    the arrows showed in the figure, put the side with the clasper to 

    the washing machine and the other side to the ground, insert base 

    cover along the direction of the upper slot of the base from the 

    back side of the washing machine.

2. Put the base cover straight to the point and then press the base 

    cover upward till there is a sound of "

Gaba" and then screw in 

    a self-tapping screw(without the self-tapping screw for plastic 

    cabinet).

Step 7:

Hole for Self-tapping screw

Slot

Base cover

Preparations before using:

1. Hang the drain hose up, the high is about 1 m.             

2. Connect the water inlet hose and open the tap. 

3. Put the power plug into the socket.    

4. Take out the coins and other sundries and shake off the mud and sand on the clothes.

5. Determine water level. Press "Water level" button to select the water level.

6. Press "Power" switch button.

7. Press "Start/Pause" button. The washing machine will go into operation by the automatic program of standard.

If you want to set other programs, please see and read 

 

"Full automatic program" and "Self-program".

According to your needs, select corresponding programs for your service.

2. It had better put the outlet of the drain hose into the nearby drainage permanently, which 

can save the trouble that the drain hose has to be connected each time before use.  If the 

drainage is far from the washing machine, it can be solved by connection of the drain hoses 

head with end to extend.